Wrong Bed Size Selected

If your machine do not set the nozzle in the center of the heated bed after "go to center" command and hits the front end of the Y axis after finishing the print and shows "Axis Blockage" error, then it means that your Voxelizer have wrong bed size selected. This problem mainly occurs while using old version of Voxelizer.

To fix the problem:

  1. Run the Voxelizer software.
  2. Click on "Select Printer" icon.

1.jpg2.jpg

  1. Select "ZMorph 2.0" not "ZMorph 2.0 XL".
  2. After this, all left to do is reseting the Voxelizer software.
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Please sign in to leave a comment.