Loading the filament - Dual PRO Extruder

  • Prepare the material. Two spools of material are included in the package (Full set). Take out the filament rolls from the plastic foil and remove the moisture absorber from inside the spool,

IMG_6006.jpg

  • You can find out what kind of filament you own by looking at the sticker on the filament spool. ZMorph VX package comes with 0.5 kg white and silver 1.75mm PLA materials,

IMG_6007.jpg

  • Slide the material on the spoolholder bar and place it on the machine,

IMG_6016.jpg

  • Enter the ‘Maintenance’ menu,

1-3_maintenance.bmp

  • Go to the ‘Load Filament’ section,

3-3_load_fil.bmp

  • Press the 'PARK TOOL' option, wait for the machine to position the toolhead,

park_tool_2.bmp

  • When the machine is done, press one of the 'PREHEAT' buttons depending on the material inside extruder,

preheat.bmp


Note: The 'PREHEAT PLA' button will heat the nozzle up to 200°C and the 'PREHEAT ABS' button will heat the nozzle up to 235°C.


  • Take off the front cover,

IMG_6019.jpg

  • Straighten the tip of filament up or cut its ends,

IMG_6005.jpg

  • Wait for the extruder to heat up. The yellow HEATING sign ikona_mini_2.bmp will change to the green READY sign ikona_mini.bmp,

heat_icon.bmp

  • Insert the filament into the left side guide hole on top of the extruder,

IMG_6021.jpg

  • Enter the LOAD/UNLOAD option,

load_unload.bmp

  • Tap the bottom arrow for the 'LEFT' extruder to feed 80 mm of the material,

feed_retract_3DH.bmp

  • Push the filament down until you feel it has been grabbed by the extruder drive gear,

IMG_6022.jpg

  • Insert the second filament into the right side guide hole on top of the extruder,

IMG_6023.jpg

  • Tap the bottom arrow for the 'RIGHT' extruder to feed 80 mm of the material,

feed_retract_4DH.bmp

  • Push the filament down until you feel it has been grabbed by the extruder drive gear,

IMG_6024.jpg

  • Wait until the material flows out of the nozzle. Tap the feed button again if necessary. 

IMG_6025.jpg


Note: Third option named 'ALL' maintain both filaments at the same time. press down arrow with to feed both filaments.

feed_retract_5DH.bmp

Note: By triggering the button showing ‘80mm’ you can change the amount of extruded filament to 15mm or 5mm.

toggle.bmp


Have more questions? Submit a request

Comments

Please sign in to leave a comment.