Removing the filament - Dual PRO Extruder

• Enter the ‘Maintenance’ menu,

• Go to the ‘Load Filament’ section,

• Press the 'PARK TOOL' option, wait for the machine to position the toolhead,

• When the machine is done, press one of the 'PREHEAT' buttons depending on the material inside extruder,

Note: The 'PREHEAT PLA' button will heat the nozzle up to 200°C and the 'PREHEAT ABS' button will heat the nozzle up to 235°C.

• Wait for the extruder to heat up. The yellow HEATING sign  will change to the green READY sign ,

• Enter the LOAD/UNLOAD option,

• Tap the upper arrow for the 'LEFT' extruder to remove 80 mm of the material. At first, extruder will load 40 mm to prevent clogging. Repeat if needed,

• Tap the upper arrow for the 'RIGHT' extruder to remove 80 mm of the material. At first, extruder will load 40 mm to prevent clogging. Repeat if needed,

Note: Third option named 'ALL' maintain both filaments at the same time. press down arrow with to feed both filaments.

Note: By triggering the button showing ‘80mm’ you can change the amount of retracted filament to 15mm or 5mm.