- Place toolhead in convenient position before removing worktable.
Note: The user can move the toolhead manually by disabling the motors by:
- pressing the reset button,
- powering down the machine,
- parking the toolhead in the 'Change toolhead' section,
- waiting 1 minute for the standby mode.
- Slide the table backwards,
- Disconnect the table plug,
- Pull the worktable forward,
- Pull the lever placed on the left to unlock the heated table,
- Lift the table with a little bit of strength up to disconnect it from the carriage magnets,
- Take the CNC table. Notice if the magnets under the table are on the proper side,
- Place the worktable on the carriage, magnets will clip it on,
- Pull the lever back to block the table,
- Make sure that lever doesn’t block the table movement by pulling the table forward.
Comments
Please sign in to leave a comment.